Hasselblad H3DII - Customizable Button Functions

17
Customizable button function list
• TheUSER, AE-L, STOP DOWN and M.UP buttons can all be reassigned to different functions.
• TheUSER button has no function until specifically assigned one (default is ‘None’). The AE-L, STOP DOWN and M.UP
buttons, however, by default are assigned the function appropriate to the name, until assigned otherwise, as follows:.
None
e user button has no function.
Standby
Sets the camera in standby mode to save battery consump-
tion.
Stop down
Stops the lens down to the chosen aperture.
Flash Measure
Initiates ash measure function.
Interval timer
Initiates interval timer function.
Self timer
Initiates self timer function.
Bracketing
Initiates bracketing function.
AF Drive
Activates the AF system in any focusing mode. When the
button is pressed the AF system sets the correct focusing point
automatically. is is a rapid, accurate and handy way of
using the AF system when the camera is set to manual focus
mode. In this manner you take advantage of the accuracy
and certainty of the autofocus system while retaining the
control inherent in manual focusing mode.
Mirror up
Controls the mirror up or down function (same function
as the M-UP button).
B mode
Sets the camera to B exposure mode.
T mode
Sets the camera to T exposure mode.
Histogram
Recalls the last shown histogram on the grip display.
Grey balance exp.
Initiates a grey balance exposure using the marker frame
to select the desired tone.
Cycle LM mode
Changes the light-metering method in a loop manner: Centre
Weighted/CentreSpot/Spot.
Delete last image
Activates the delete function for the last capture.
Dig. foc check
Displays last capture at 100% scale to check focus.
IAA toggle
Allows IAA rating change of last capture.
Expose
Acts as alternative shutter release button.
AE-lock
Activates AE lock function.
A quick way to program the customizable buttons (and
to access the Custom Option level in general) is to use
the short-cut as follows:
1) Press the MENU button.
2) Then press the USER button.
This directly accesses the “Custom options” level in the menu
where you can access the desired option for a setting change.