126
2. Fold the tissue several times to match the width of the IR lter—you might use two
or three tissues at a time if necessary (to give you a better grip). Be sure to fold the
paper so that the coated glossy side faces outwards—do not use the other side, as it
can do more harm than good!
3. Gently place the folded tissue onto the edge of the lter using two or three ngers.
Be sure to wipe the entire surface evenly. Sweep the lter only once. Do not wipe the
same area twice with the same tissue as you might reapply dirt removed in the rst
sweep.
4. Finally check if the IR lter has been properly cleaned either by visual inspection or
by mounting the digital capture unit to the camera and making a shot. If further
cleaning is needed, repeat cleaning procedure.
Cleaning with an E-Wipe
E-wipes are individually packed wet tissues.
1. Tear at the notch to break seal.
2. Remove e-wipe from its packaging and continue without delay.
3. Fold the tissue to match the width of the IR lter.
4. Apply rm pressure using two or three ngers at the edge of the wipe to ensure an
even, rm contact with lter surface. Wipe the surface in one unbroken motion.
Note! Do not use same side of the e-wipe twice as you will be likely to reapply any
particles removed in the rst pass.
5. Finally check if the IR lter has been properly cleaned either by visual inspection or
by mounting the digital capture unit to the camera and making a shot. If further
cleaning is needed, repeat cleaning procedure.
Attaching the digital capture unit
Position the digital capture unit retention groove onto the digital capture unit support
on the camera body ensuring that they are correctly positioned. Swing the digital capture
unit towards the camera body and rmly press into place with a click. If there is resistance,
the magazine retaining catch on the camera has probably been inadvertently released.
In that case, push the release button again to reset the catch.
Cleaning the housings
If the camera becomes dirty, clean it with a so, clean cloth lightly moistened with water
only. Do not use any other solvents and do not allow water to seep in the openings.
To Next Page
Loading...
