Hasselblad H3DII - Page 74

74
Setting CAMERA model and options
ese settings are only available when the digital capture unit
is not attached to an H3D II body.
Proceed as follows:
1. Press the menu (MENU) button to open the menu.
2. Use  and  to select the SETTINGS sub-menu.
3. Press  to open the SETTINGS menu.
4. Use  and  to select CAMERA.
5. Press  to open the CAMERA menu.
6. Press either the
+
or
–
button to select camera model.
7. Use  and  to select EXPOSURE TIME or CAPTURE SEQ.
if required.
8. Press either the
+
or
–
button to make new settings if
required.
9. Press the menu (EXIT) button to exit the menu system and
keep your settings.
OptionsavailableforPINHOLEandFLASHSYNC
Shutter Delay
e normal setting is Default and cannot be changed.
Exposure Time
is setting should be changed for cable-free exposure times longer
than 1/8 second, ensuring that it matches the shutter speed/expo-
sure time on the camera/lens. e settings range from 1/8 second
to 32 seconds (1/8 second is the default setting).
Capture Sequence
is feature functions in the same manner as an interval timer.
Initial delay: Controls the amount of time required to elapse
before the rst capture.
Delay: Controls the amount of time required between each
capture.
Count: Controls the total number of captures required.
21
3 4
5
9
6
7 8