HDL KNX / EIB Switch Actuators
_____________________________________________________________________________________
Guangzhou Hedong Electronic Co.,Ltd (HDL)
www.hdlchina.com 14/58
number of associations and max. number of the
group addresses
Note: ETS2V1.3-> Import “VD2”
ETS3.0-> Import “VD3” to “VD5”.
ETS4-> Import “.KNXPROD”.
3.3 Function parameter “General”
Fig1: “General” parameter windows
In the parameter of the general windows can set two parameters
“
Switching delay after recovery ” and “Cycle send general telegram”.
---Switching delay after recovery(2..200s)
Can operate relay for a delay time 2..200s after the power on. The
default value is 2 seconds. The Min. value is 2 seconds, and the max.
value is 200 seconds.
Options: 2…200s
When the power on and timer start, and when the time out, The switch
can be allow operating .
This function is selected by user
---Cycle send general telegram(1..65535s,0-invalid)
The range of the parameter is 0 to 65535s. Zero of parameter
disable the function , other of parameter enable this function
To Next Page
Loading...
Need help?
General