HDL KNX / EIB Switch Actuators
_____________________________________________________________________________________
Guangzhou Hedong Electronic Co.,Ltd (HDL)
www.hdlchina.com 34/58
The blinds function need combination two channels work together.
the first channel control UP/Adjust/Stop of Blind and the second
channel control DOWN/Adjust/Stop of blinds. It runs by receiving
telegram value ‘0’/’1’ from the bus and stop when timeout or receiving
adjustment object telegram value.
---Blinds UP(‘0’-value)
The first channel for blinds UP or adjustment.
Options: channel “N”(N=current channel)
This channel output control blinds UP or adjustment.
---Blinds DOWN(‘1’-value)
It’s can select another channel as second channel for blinds DOWN
Options: channel “M”(M= another channels )
e.g. If first channel is “channel A” and the maximum channel number
is 4 of the device, can only select channel B or channel C or channel
D for second channel
Control mode
Options: Move UP/DOWN and Adjustment
Move UP/DOWN
Move UP/DOWN and Adjustment: This selection can control the
blinds UP or DOWN,can adjust the blinds,too.
Move UP/DOWN: This selection can only control the blinds UP or
DOWN
---Adjustment time
This parameter set blinds adjustment time.
The maximum time 5
seconds,Minimum time is 50ms
---Delay time for running direction changed
When running direction changed,Delay for inertia. The maximum time 5
seconds,Minimum time is 50ms
---Moving time(2..65535s):
This parameter set blinds moving need to take total time.
Options:0.. 65535s
To Next Page
Loading...
Need help?
General