Unpacking and Setting up 1
TANGO / TANGO XL – Operation 1–9
■
Positioning the ramp
The ramp can be positioned at the front or
the back, as required.
Hook the ramp onto the pre-drilled holes of
pallet using the two prongs.
Now, with the ramp in place, you can pull
the scanner off the pallet from the front or
push it off from the back. Hold on to the
scanner so that it doesn’t roll down the
ramp by itself!
Note:
You will need a length of about 3 m for the
pallet, ramp and the area the unit covers
itself.
■
Push the scanner to the setting up site
You can now pull/push the scanner to its
intended final location.
To Next Page
Loading...
