1 Unpacking and Setting up
1–10 Edition October 1998
To negotiate bends, you can rotate the
scanner to the right direction by raising the
carrying plate on one side.
The location where the scanner is to be
used must ensure the following characteris-
tics:
Distance from the wall at least 50 cm
(in order to remove transport safeguards/
allow service access)
Ceiling height at least 2.20 m
(in order to raise the cover)
In the case of uneven floors, we recommend
that you:
– have the unit set up by the service
department
or
– place a 1 cm thick aluminum plate,
62x62 cm under the unit. You will also
need a ramp for the aluminum plate.
Adjust the plate so that it is flat and
cannot wobble horizontally.
In the case of slight degrees of unevenness,
you can adjust the feet for height later on.
Notes:
Pay attention to the
length of the SCSI con-
nection cable
between scanner and Power
Macintosh!
You must position the scanner very care-
fully at the final location.
You must not move the scanner when it is
standing on its own feet since they are not
suitable for this and could be damaged.
To be able to change the location at a later
date, the scanner must again be placed on
its transport rollers.
Pay attention to SCSI cable length
1
Do not move the
scanner any more!
To Next Page
Loading...
