Unpacking and Setting up 1
TANGO / TANGO XL – Operation 1–17
■ Altering the height of the unit’s feet
The feet are factory-set to require no fur-
ther adjustment when the unit is on level
ground.
You can only achieve ideal stability for the
unit through altering the height of the
feet where deviations in floor level are min-
imal.
In the case of uneven floors, we recommend
that you:
– have the unit set up by the service
department
or
– place a 1 cm thick aluminum plate,
62x62 cm under the unit. You will also
need a ramp for the aluminum plate.
Adjust the plate so that it is flat and
cannot wobble horizontally.
The tendency to wobble must be equal on
all sides. You can check this, by trying to
make the unit wobble diagonally.
If the wobble tendency is greater on one
side than on the other, you can correct this
by increasing the height of the rear foot, on
the side that the unit tends to lean to.
To Next Page
Loading...
