HEIDENHAIN PWT 101 - Figure 8: Module Action in the Flash Memory Screen

Module management | Module action screen
Module action in the flash memory screen
Figure 8: Module action in the flash memory screen
The following buttons are available for a module in the flash memory:
Active (module is activated)
For information only, no action is possible
Start (module is deactivated)
Start the module. This makes the module the active module.
Remove
Remove the module from the flash memory (after confirmation prompt)
Details
Information on the module
3
HEIDENHAIN | PWT 101 Block Commutation Module | User's Manual | 07/2021
23