New and changed cycle functions of software 77185x-04
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
11
New and changed cycle functions of
software 77185x-04
New Cycle 258 POLYGON STUD, see "POLYGON STUD (Cycle
258, DIN/ISO: G258)", page 159
Cycle 225 has been expanded by parameters Q516, Q367,
and Q574. This makes it possible to define a datum for the
respective text position, as well as to scale the text length
and character height. The pre-positioning for engraving on a
circular path has changed, see "ENGRAVING (Cycle 225, DIN/
ISO: G225)", page 282
In Cycles 481 to 483, parameter Q340 was expanded with
the input option "2". This makes it possible to check the tool
without changing the tool table, see "Measuring tool length
(Cycle 31 or 481, DIN/ISO: G481)", page 453, see "Measuring
tool radius (Cycle 32 or 482, DIN/ISO: G482)", page 455,
see "Measuring tool length and radius (Cycle 33 or 483, DIN/
ISO: G483)", page 457
Cycle 251 has been expanded by parameter Q439. In addition,
the strategy for finishing was revised, see "RECTANGULAR
POCKET (Cycle 251, DIN/ISO: G251)", page 131
In Cycle 252, the strategy for finishing was revised, see
"CIRCULAR POCKET (Cycle 252, DIN/ISO: G252)", page 136
Cycle 275 has been expanded by parameters Q369 and
Q439, see "TROCHOIDAL SLOT (Cycle 275, DIN/ISO: G275)",
page 208
Cycle 247 DATUM SETTING: The number of the preset can be
selected from the preset table, see "DATUM SETTING (Cycle
247, DIN/ISO: G247)", page 257
Cycles 200 and 203: The behavior of the dwell time at top was
modified, see "UNIVERSAL DRILLING (Cycle 203, DIN/ISO:
G203)", page 74
Cycle 205 performs deburring on the coordinate surface,
see "UNIVERSAL PECKING (Cycle 205, DIN/ISO: G205)",
page 81
For SL cycles, M110 is now taken into account for arcs
compensated on the inside of the arc if M110 is active during
machining, see "SL Cycles", page 186
To Next Page
Loading...
