HEIDENHAIN TNC 320 - Allowed Engraving Characters; Characters that Cannot be Printed

ENGRAVING (Cycle 225, DIN/ISO: G225) 11.6
11
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
285
Allowed engraving characters
The following special characters are allowed in addition to
lowercase letters, uppercase letters and numbers:
! # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ \ ] _ ß CE
The TNC uses the special characters % and \
for special functions. These characters must be
indicated twice in the text to be engraved (e.g. %%) if
you want to engrave them.
When engraving German umlauts, ß, ø, @ or the CE character,
enter the character % before the character to be engraved:
Algebraic sign Input
ä %ae
ö %oe
ü %ue
Ä %AE
Ö %OE
Ü %UE
ß %ss
ø %D
@ %at
CE %CE
Characters that cannot be printed
Apart from text, you can also define certain non-printable
characters for formatting purposes. Enter the special character \
before the non-printable characters.
The following formatting possibilities are available:
Character Input
Line break \n
Horizontal tab
(the tab width is permanently set to 8
characters)
\t
Vertical tab
(the tab width is permanently set to one
line)
\v