HEIDENHAIN TNC 320 - Touch Probe Table; General Information; Editing Touch Probe Tables

Using Touch Probe Cycles
12.3 Touch probe table
12
300
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
12.3 Touch probe table
General information
Various data is stored in the touch probe table that defines the
probe behavior during the probing process. If you use several touch
probes on your machine tool, you can save separate data for each
touch probe.
Editing touch probe tables
To edit the touch probe table, proceed as follows:
Operating mode: Press the Manual operation key
To choose the touch probe functions, press
the TOUCH PROBE soft key. The TNC displays
additional soft keys
To select the touch probe table, press the TCH
PROBE TABLE soft key
Set the EDIT soft key to ON
Using the arrow keys, select the desired setting.
Perform desired changes.
To leave the touch probe table, press the END soft
key.