FACE MILLING (Cycle 232, DIN/ISO: G232) 11.7
11
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
289
Please note while programming:
Enter Q204 2ND SET-UP CLEARANCE so that no
collision with the workpiece or the fixtures can occur.
If Q227 STARTNG PNT 3RD AXIS and Q386 END
POINT 3RD AXIS are entered as equal values, the
TNC does not run the cycle (depth = 0 has been
programmed).
Program Q227 greater than Q386. Otherwise, the
TNC will display an error message.
To Next Page
Loading...
