BASIC ROTATION over two studs (Cycle 402, DIN/ISO: G402) 13.4
13
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
313
Cycle parameters
Q268 1st stud: center in 1st axis? (absolute):
Center of the first stud in the reference axis of
the working plane. Input range -99999.9999 to
99999.9999
Q269 1st stud: center in 2nd axis? (absolute):
Center of the first stud in the secondary axis of
the working plane. Input range -99999.9999 to
99999.9999
Q313 Diameter of stud 1?: Approximate diameter
of the first stud. Enter a value that is more likely
to be too large than too small. Input range 0 to
99999.9999
Q261 Meas. height stud 1 in TS axis? (absolute):
coordinate of the ball tip center (= touch point in the
touch probe axis) at which stud 1 is to be measured.
Input range -99999.9999 to 99999.9999
Q270 2nd stud: center in 1st axis? (absolute):
Center of the second stud in the reference axis
of the working plane. Input range -99999.9999 to
99999.9999
Q271 2nd stud: center in 2nd axis? (absolute):
Center of the second stud in the secondary axis
of the working plane. Input range -99999.9999 to
99999.9999
Q313 Diameter of stud 2?: Approximate diameter
of the second stud. Enter a value that is more likely
to be too large than too small. Input range 0 to
99999.9999
Q315 Meas. height stud 2 in TS axis? (absolute):
coordinate of the ball tip center (= touch point in the
touch probe axis) at which stud 2 is to be measured.
Input range -99999.9999 to 99999.9999
Q320 Set-up clearance? (incremental): Additional
distance between measuring point and ball tip.
Q320 is added to SET_UP in the touch probe table.
Input range 0 to 99999.9999
Q260 Clearance height? (absolute): coordinate in
the touch probe axis at which no collision between
tool and workpiece (fixtures) can occur. Input range
-99999.9999 to 99999.9999
Q301 Move to clearance height (0/1)?: Definition
of how the touch probe is to move between the
measuring points:
0: Move at measuring height between measuring
points
1: Move at clearance height between measuring
points
NC blocks
5 TCH PROBE 402 ROT OF 2 STUDS
Q268=-37 ;1ST CENTER 1ST AXIS
Q269=+12 ;1ST CENTER 2ND AXIS
Q313=60 ;DIAMETER OF STUD 1
Q261=-5 ;MEAS. HEIGHT STUD 1
Q270=+75 ;2ND CENTER 1ST AXIS
Q271=+20 ;2ND CENTER 2ND AXIS
Q314=60 ;DIAMETER OF STUD 2
Q315=-5 ;MEAS. HEIGHT STUD 2
Q320=0 ;SET-UP CLEARANCE
Q260=+20 ;CLEARANCE HEIGHT
Q301=0 ;MOVE TO CLEARANCE
Q307=0 ;PRESET ROTATION
ANG.
Q305=0 ;NUMBER IN TABLE
Q402=0 ;COMPENSATION
Q337=0 ;SET TO ZERO
To Next Page
Loading...
