ENGRAVING (Cycle 225, DIN/ISO: G225) 11.6
11
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
283
Cycle parameters
QS500 Engraving text?: Text to be engraved, inside
quotation marks. Assignment of a string variable
through the Q key of the numerical keypad. The Q
key on the ASCI keyboard represents normal text
input. Allowed entry characters: see "Engraving
system variables", page 286
Q513 Character height? (absolute): Height of the
characters to be engraved in mm. Input range 0 to
99999.9999
Q514 Character spacing factor?: The font used is a
proportional font. Each character has its own width,
which is engraved correspondingly by the TNC if you
program Q514 = 0. If Q514 is not equal to 0, the
TNC scales the space between the characters. Input
range 0 to 9.9999
Q515 Font?: Currently without function
Q516 Text on a line/on an arc(0/1)?:
Engrave the text in a straight line: Input = 0
Engrave the text on an arc: Input = 1
Engrave the text on an arc, circumferentially (not
necessarily legible from below): Input = 2
Q374 Angle of rotation?: Center angle if the text
is to be arranged on an arc. Engraving angle when
text is in a straight line. Input range -360.0000 to
+360.0000°
Q517 Radius of text on an arc? (absolute): Radius
of the arc in mm on which the TNC is to arrange the
text Input range 0 to 99999.9999
Q207 Feed rate for milling?: Traversing speed of
the tool in mm/min during milling. Input range 0 to
99999.999 alternatively FAUTO, FU, FZ
Q201 Depth? (incremental): Distance between
workpiece surface and engraving floor
Q206 Feed rate for plunging?: Traversing speed of
the tool in mm/min during plunging. Input range 0 to
99999.999 alternatively FAUTO, FU
Q200 Set-up clearance? (incremental): Distance
between tool tip and workpiece surface Input range
0 to 99999.9999; alternatively PREDEF
Q203 Workpiece surface coordinate? (absolute):
Coordinate of the workpiece surface. Input range
-99999.9999 to 99999.9999
NC blocks
62 CYCL DEF 225 ENGRAVING
QS500="A" ;ENGRAVING TEXT
Q513=10 ;CHARACTER HEIGHT
Q514=0 ;SPACE FACTOR
Q515=0 ;FONT
Q516=0 ;TEXT ARRANGEMENT
Q374=0 ;ANGLE OF ROTATION
Q517=0 ;CIRCLE RADIUS
Q207=750 ;FEED RATE FOR
MILLNG
Q201=-0.5 ;DEPTH
Q206=150 ;FEED RATE FOR
PLNGNG
Q200=2 ;SET-UP CLEARANCE
Q203=+20 ;SURFACE COORDINATE
Q204=50 ;2ND SET-UP
CLEARANCE
Q367=+0 ;TEXT POSITION
Q574=+0 ;TEXT LENGTH
To Next Page
Loading...
