Touch Probe Cycles: Automatic Datum Setting
14.12 DATUM AT CENTER OF 4 HOLES (Cycle 418, DIN/ISO: G418)
14
366
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
Please note while programming:
Danger of collision!
If you set a datum (Q303 = 0) with the touch probe
cycle and also use probe in TS axis (Q381 = 1), then
no coordinate transformation must be active.
Before a cycle definition you must have programmed
a tool call to define the touch probe axis.
To Next Page
Loading...
