HEIDENHAIN TNC 320 - Hiding Single Points from the Machining Process; Selecting a Point Table in the Program

Point tables 2.4
2
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
61
Hiding single points from the machining process
In the FADE column of the point table you can specify if the defined
point is to be hidden during the machining process.
In the table, select the point to be hidden
Select the FADE column
Activate hiding, or
NO
ENT
Deactivate hiding
Selecting a point table in the program
In the Programming mode of operation, select the program for
which you want to activate the point table:
Press the PGM CALL key to call the function for
selecting the point table
Press the POINT TABLE soft key
Enter the name of the point table and confirm your entry with the
END key. If the point table is not stored in the same directory as the
NC program, you must enter the complete path.
Example NC block
7 SEL PATTERN "TNC:\DIRKT5\NUST35.PNT"