THREAD MILLING/COUNTERSINKING (Cycle 263, DIN/ISO: G263) 4.7
4
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
111
Please note while programming:
Program a positioning block for the starting point
(hole center) in the working plane with radius
compensation R0.
The algebraic sign of the cycle parameters depth
of thread, countersinking depth or sinking depth at
front determines the working direction. The working
direction is defined in the following sequence:
1. Thread depth
2. Countersinking depth
3. Depth at front
If you program a depth parameter to be 0, the TNC
does not execute that step.
If you want to countersink at front, define the
countersinking depth as 0.
Program the thread depth as a value smaller than the
countersinking depth by at least one-third the thread
pitch.
Danger of collision!
Enter in machine parameter displayDepthErr
whether the TNC should output an error message
(on) or not (off) if a positive depth is entered.
Keep in mind that the TNC reverses the calculation
for pre-positioning when a positive depth is
entered. This means that the tool moves at rapid
traverse in the tool axis to set-up clearance below
the workpiece surface!
To Next Page
Loading...
