HEIDENHAIN TNC 320 - Recording the Results of Measurement

Fundamentals 15.1
15
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
377
Soft key Cycle Page
427 MEASURE COORDINATE
(2nd soft-key row) Measuring any
coordinate in a selectable axis
407
430 MEASURE BOLT HOLE CIRCLE
(2nd soft-key row) Measuring position
and diameter of a bolt hole circle
410
431 MEASURE PLANE
(2nd soft-key row) Measuring the A
and B axis angles of a plane
413
Recording the results of measurement
For all cycles in which you automatically measure workpieces (with
the exception of Cycles 0 and 1), you can have the TNC record
the measurement results. In the respective probing cycle you can
define if the TNC is to
Save the measuring log to a file
Interrupt program run and display the measuring log on the
screen
Create no measuring log
If you want to save the measuring log to a file the TNC, by default,
saves the data as an ASCII file. The TNC will save the file in the
directory that also contains the associated NC program.
Use the HEIDENHAIN data transfer software
TNCRemo if you wish to output the measuring log
over the data interface.