HEIDENHAIN TNC 320 - Page 9

New cycle functions of software 77185x-01
HEIDENHAIN | TNC 320 | User’s manual for cycle programming | 9/2016
9
New cycle functions of software 77185x-01
The character set of the fixed cycle 225 Engraving was
expanded by more characters and the diameter sign see
"ENGRAVING (Cycle 225, DIN/ISO: G225)", page 282
New machining cycle 275 Trochoidal milling see "TROCHOIDAL
SLOT (Cycle 275, DIN/ISO: G275)", page 208
New machining cycle 233 Face milling see "FACE MILLING
(Cycle 233, DIN/ISO: G233)", page 164
In Cycle 205 Universal Pecking you can now use parameter
Q208 to define a feed rate for retraction see "Cycle parameters",
page 83
In the thread milling cycles 26x an approaching feed rate was
introduced see "Cycle parameters", page 108
The parameter Q305 NUMBER IN TABLE was added to Cycle
404 see "Cycle parameters", page 318
In the drilling cycles 200, 203 and 205 the parameter Q395
DEPTH REFERENCE was introduced in order to evaluate the T
ANGLE see "Cycle parameters", page 83
Cycle 241 SINGLE-LIP DEEP HOLE DRILLING was expanded
by several input parameters see "SINGLE-LIP DEEP-HOLE
DRILLING (Cycle 241, DIN/ISO: G241)", page 87
The probing cycle 4 MEASURING IN 3-D was introduced see
"MEASURING IN 3-D (Cycle 4)", page 423