S321 User Guide Chapter 3
Setup and Configuration Page 38 of 65
NMEA Message
Turn the NMEA messages on.
Satellites
If you wish to exclude a specific satellite, select the Don’t track checkbox next to that satellite in
the list.
Note: This function is only available if you have hardware version S321‐v1.1 (see “Information”
tab) or higher, these messages will come out of the 5‐pin serial port at the same baud rate as the
External Serial Port Baud Rate (as shown above). This function cannot be used if you are using
an external device for RTK.
To Next Page
Loading...
