41
2
Description
2.4.4
Symbols for parameters
These are shown in the menu for extended settings and in the menu for device settings, as well
as on the corresponding screens for numerical inputs
Dispensing rate
(Dispensing quantity per time unit)
Dispensing quantity
Dispensing time
Suck-back volume set-up
Suck-back should only be used if really
necessary as it increases process time as well
as pump wear.
Flow rate during suck-back
(suck-back quantity per time unit)
Rotor lag time
Pump calibration
(Set-up the exact dispensed volume per
revolution, used to calibrate the pump)
Ramp up time of the flow rate.
Available in start/stop operating mode only.
Ramp down time of the flow rate.
Available in start/stop operating mode only.
To Next Page
Loading...
