HERO MAESTRO EDGE PROGRAMMED FI - Tyre Tread Wear and Replacement

23
Inspection
Look for:
Whenever you check the tyre pressure, you
should also examine tyre treads & side walls
for wear, damage & foreign objects.
•
Bumps or bulges in the side of the tyre or
the tread. Replace the tyre if you find any
bumps or bulges.
•
Cuts, splits or cracks in the tyre. Replace the
tyre if you can see fabric or cord.
•
Excessive tread wear.
Minimum tread depth:
•
Carefully inspect the tyres for any damage,
if the vehicle hits a pothole or hard object.
Replace tyres immediately when the wear
indicator (1) appears on the tyre. The tread
limits are :
Front: 1.0 mm Rear: 1.0 mm
Tread wear
Check the tread wear indicator for tyre wear.
(1) Tread wear indicator (2) Arrow mark
TWI
1
2
1
The recommended “cold” tyre pressures are:
CAUTION
!!
Over inflation/Under inflation will affect the
performance.
Front
Rear
2
1.50 kgf/cm (22 psi)
2
2.00 kgf/cm (29 psi)
2
1.50 kgf/cm (22 psi)
2
2.50 kgf/cm (36 psi)
Rider only Rider and Pillion