66
BULB/LED REPLACEMENT
Refer to the safety precautions (page 52).
The bulb becomes very hot while the lamp is
“ON”, and remains hot for a while after it is
turned “OFF”. Be sure to let it cool down
before servicing.
it with a cloth moistened with alcohol to
prevent its early failure.
•
Be sure to turn the ignition switch “OFF”
when replacing the bulb.
•
Do not use bulbs other than that specified.
•
After installing a new bulb, check that the
lamp operates properly.
(a) Headlamp
•
Remove the headlamp assembly (page 40).
•
Disconnect the headlamp connector (1).
•
Remove the dust cover (2).
Do not put finger prints on the headlamp bulb,
as they may create hot spots on the bulb and
cause it to break.
Wear clean gloves while replacing the bulb. If
you touch the bulb with your bare hands, clean
•
Loosen the screw and release the clip (3)
from its position.
•
Check the rear shock absorber by pushing
hard downwards on rear grip while the
vehicle is not parked on stand. The vehicle
action should be smooth and there should
be no oil leakage.
(2) Dust cover (3) Clip
(1) Headlamp connector
1
2
3
•
Remove the headlamp bulb (4) without
turning.
To Next Page
Loading...
