44
NOTE
If MIL remains “ON” even if the vehicle is
started, there is an abnormality in the
programmed FI system. It is recommended to
reduce the speed and drive to the Authorised
Hero MotoCorp workshop for check-up.
With the throttle closed, press the starter
switch.
•
Use starter switch:
Starting procedure
starter with a rapid and continuous motion.
•
Use kick starter:
•
Continue warming up the engine until it
runs smoothly and responds to the throttle.
At any ambient temperature, turn the ignition
switch to “ON” position and press the front or
integrated/rear brake lever, now press the
starter switch with the throttle completely
closed.
With the throttle closed, operate the kick
NOTE
This vehicle has a fuel-injected engine with an
idle air control valve (IACV).
•
Do not leave the vehicle unattended while
the engine is warming up.
•
Snapping the throttle or fast idling for more
than 5 minutes at normal air temperature
may cause exhaust pipe discolouration.
Ignition cut off
Your vehicle is designed to automatically stop
the engine & fuel pump, if vehicle falls down.
(Bank angle sensor cuts off the ignition).
NOTE
If the vehicle has fallen down, before restarting
the engine you must turn the ignition switch to
“OFF” ( ) position and then back to “ON”
( ) position.
(1) Ignition switch (2) Programmed FI
malfunction indicator lamp (MIL)
2
1
To Next Page
Loading...
