(1) Drain bolt (2) Sealing washer
1
2
60
(4) Spring (5) Oil strainer screen (6) O-ring
5
4
6
•
Remove the oil strainer screen cap (3).
(3) Oil strainer screen cap
3
•
The spring (4) and oil strainer screen (5)
will come out when the oil strainer screen
cap is removed.
•
Clean the oil strainer screen.
•
Check that the oil strainer screen, sealing
rubber and cap O-ring (6) are in good
condition.
• Install the oil strainer screen, spring and oil
strainer screen cap. Install the drain bolt with
new sealing washer.
• Start the engine and let it idle for 2-3
minutes. Stop the engine and ensure that the
oil level is at the upper level mark on the oil
level dipstick with the vehicle upright on flat
level surface. Ensure there are no oil leaks.
At engine disassembly: 0.80 litre
• Fill crankcase with the recommended grade
of oil:
At draining: 0.70 litre
• Install the oil level dipstick.
CAUTION
!!
• Engine oil quality is the chief factor affecting
engine service life. Replace and top-up the
engine oil as specified in the maintenance
schedule (pages 53).
• When running in very dusty conditions, oil
changes should be performed more
frequently than specified in the maintenance
schedule.
To Next Page
Loading...
