Hettich ROTOFIX 32 A - Setting an Audible Signal; Cleaning and Care; Overview Table

AB1206en_SARev.: 06 / 11.2023
30 / 39
Cleaning and care
7.3.1.2 Setting an audible signal
1.
Switch off the mains switch.
2.
Press and hold down the ▲ [RPM/RCF x 100] button and the
[IMPULSE] button simultaneously.
3. Switch on the mains switch and release the buttons.
4. Press the ▲ [RPM/RCF x 100] button repeatedly until ‘BEL 1’ or ‘BEL
0’ is displayed.
5. Use the [t] buttons beneath the time indicator to set ‘0’ or ‘1 ’ .
0 = audible signal disabled.
1 = audible signal enabled.
6. Press the [STOP] button to save the settings.
8 Cleaning and care
8.1 Overview table
Chap. Task to execute
if required
daily
weekly
Annually
Page
8 Cleaning and care     30
8.3 Cleaning     31
8.3 Cleaning the device  X   31
8.3 Cleaning the biosafety systems   X  31
8.3 Cleaning the accessories   X  32
8.4 Disinfection     32
8.4 Disinfecting the device X    32
8.4 Disinfecting the accessories X    32
8.5 Maintenance     33
8.5 Greasing the rubber seal of the centrifuging
chamber
  X  33
8.5 Greasing the rubber seal of the biosafety system   X  33
8.5 Trunnion greasing   X  33
8.5 Checking the accessories   X  33
8.5 Checking the biosafety system   X  33
8.5 Inspecting the centrifuging chamber for damage    X 33
8.5 Greasing the motor shaft    X 33
8.5 Accessories with a limited service life X    33