Using for the rst time
Page 19
heyer_LUVAR_UserManual_EN-3_CRev-1
Electronic slots
An SD card slot and a slot for electronic accessory modules are located under the
SD card cover on the left side of the respiratory therapy device. These slots are
intended to be used
• by patients and medical staff
• with the SD cards and accessory modules provided by heyer medical AG.
The slots are not intended for controlling the operation of any other medical device
or accessory.
Using for the first time
Before using this respiratory therapy device for the first time, check for obvious
damage. Do not operate the device if the housing or any cables on the device or
power supply unit are damaged.
If the respiratory therapy device has been exposed to unusually high or low ambi-
ent temperatures, give the device time to adjust to room temperature before use –
up to 2 hours, depending on the temperature difference.
Report any serious incidents that occur in relation to the device to the manufactur-
er and the competent authority.
If you need assistance with operating the device for the first time, or using or
cleaning it or wish to report unexpected operation or incidents, please contact the
specialist dealer who supplied the device. If they cannot be contacted, you can also
contact heyer medical AG directly.
Setting up the device
WARNING: Risk of injury due to restricted air supply!
• The device must not be covered or positioned in such a way that the air flow
to the device is completely or partially blocked, in order to avoid reduced
performance and the device overheating.
Ö Do not place the device near curtains.
Ö Make sure the area where the device is placed is dry, clean and free of
bedding, clothing or other objects that may block the air intake.
To Next Page
