Terminating the therapy
Page 38
heyer_LUVAR_UserManual_EN-3_CRev-1
Note: The display automatically goes dark after 1 minute. The therapy continues as
normal. Whenever you touch the display or operate the rotary knob, the therapy
screen is displayed again. The automatic screen timeout can be deactivated
(see “Setting device parameters”). We recommend leaving the automatic screen
timeout on so that you can sleep undisturbed.
During therapy, you can switch to the advanced therapy screen or make changes to
the ramp time and heating level. For more information on the therapy screen, see
section “Therapy screen (standard)”.
In the event of a power failure, the respiratory therapy device informs you with a
brief audible signal. All settings are retained. Once the power supply returns, the
therapy can be restarted as usual.
Terminating the therapy
In order to terminate the therapy, press and hold the “Stop” button while 3 seconds
are counted down as shown on the screen.
If the “Automatic Stop” function is activated (see “Setting a comfort parameter”),
simply take off the mask. The therapy will then be terminated automatically after
approx. 5 seconds.
Switching off the device
Once therapy is complete, the device goes into standby mode again. If the auto-
matic screen timeout is activated, the screen switches off after 5 minutes. The
device can remain in this operating mode continuously without any danger.
To switch off the device completely, you can disconnect the power plug from the
socket or the angled DC plug from the respiratory therapy device.
Patient settings
From the home screen, you can access the patient settings menu, where you will
find submenus for comfort parameters, device parameters, time and date and
accessory parameters.
Setting a comfort parameter
On the home screen, select the “Settings” button and navigate to the “Comfort”
item in the “Settings” screen.
To Next Page
Loading...
