Patient settings
Page 39
heyer_LUVAR_UserManual_EN-3_CRev-1
Parameter
Setting range
Standard
Description
Automatic Start ON
OFF
Activate or deactivate automatic switch-on
here.
If this function is activated, therapy begins
as soon as you inhale and exhale.
If this function is deactivated, you must start
therapy using the “Start” button.
Automatic Stop ON
OFF
Activate or deactivate automatic switch-off
here.
If this function is activated, therapy ends 5
seconds after taking off the mask. Therapy
will also end if the mask slips off your face or
there is leakage that cannot be compensated
for.
If this function is deactivated, you must end
the therapy using the “Stop” button.
Ramp time 5 … 30 … 60
min
The ramp function makes it easier to get
used to the therapy pressure while going to
sleep. This is where you can set the time over
which the pressure increases from the start
pressure (ramp start pressure) to the therapy
pressure.
If the ramp time is switched off, therapy
starts immediately with the prescribed thera-
py pressure.
Note: The start pressure is set by your physi-
cian between 4 hPa and the prescribed
therapy pressure.
To Next Page
Loading...
