EasyManua.ls Logo

Heyer LUVAR A - Connecting the Power Supply; Inserting the Air Filter

Default Icon
80 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using for the rst time
Page 20
heyer_LUVAR_UserManual_EN-3_CRev-1
WARNING: Risk of re and burns!
Oxygen sources must be more than 1 m away from the device to avoid the
risk of fire and burns.
CAUTION: Risk of damage to device due to water ingress!
Make sure that the device is protected from water when used outdoors.
Place the device on a firm, level surface next to the bed (e.g. on a bedside table).
Make sure that the device is securely positioned and cannot be knocked by any-
thing. The position must allow sufficient space for the device itself as well as the
component parts connected during operation.
The device draws in dry ambient air for respiratory therapy through the air filter
on the left side of the device. To avoid obstructing the air supply, the device should
be at least 20 cm away from walls and other objects at all times. Avoid placing
near radiators and room humidifiers. To avoid the material aging prematurely, the
device should not be placed anywhere exposed to direct sunlight at any part of the
day.
Connecting the power supply
1. Connect the power cable to the power supply unit.
Note: The power cable serves as a device for quickly and fully disconnecting the
respiratory therapy device from the power supply at any time. Therefore, always
position the power cable so that you can easily disconnect it from the power
outlet or the power supply unit.
2. Insert the angled DC plug on the power supply unit into the power supply
connection on the respiratory therapy device.
3. Lay the power cable so that no one can trip over it and insert the power plug
into the mains socket (100-240 VAC, 50/60 Hz).
The device will start up automatically. The flash screen showing the heyer logo is
displayed for around 20 seconds. The display then switches to the home screen
and the device is ready for operation.
Inserting the air filter
Note: The air lter prevents particles 10 μm and above from getting in. Never oper-
ate the device without the air lter. Only use the air lters recommended by
heyermedical AG.

Table of Contents

Related product manuals