Heyer Pasithec - User Manual

Questions and Answers

M
Manuel HendersonAug 13, 2025
How to fix a breathing system leak in Heyer Pasithec?
- P
  Paul BrownAug 14, 2025
  A breathing system leak in Heyer Medical Equipment can occur for several reasons. Check if the APL valve is on and turn it off if it is. Ensure the canister is sealed well; reinstall or remove any natrium calcareousness grains at the joint. Inspect the corrugated tubing for breaks or loose connectors, and replace or reinstall as necessary. Finally, make sure all valves are tightened properly.
D
Dr. Richard CraneAug 17, 2025
What to do if the maximum pressure alarm sounds continuously on Heyer Medical Equipment?
- T
  todd06Aug 17, 2025
  If the maximum pressure alarm sounds continuously on your Heyer Medical Equipment, several factors could be the cause. First, check the breathing system for any occlusions and adjust accordingly. Next, examine the patient for any respiratory tract occlusions. Also, verify that the maximum pressure setting isn't too low and readjust if needed. Finally, if ventilator parameters have changed, recalculate them.
T
timothygreeneAug 21, 2025
Why the AC indicator has no power, and ventilator does not work in Heyer Pasithec?
- I
  Isabel JohnsonAug 21, 2025
  If the AC indicator has no power and the ventilator isn't working on your Heyer Medical Equipment, check the following: Ensure the power supply cable is properly plugged in. Verify that the power switch is turned on. Finally, inspect the fuse and replace it if it's burned out.
K
Kevin CainAug 25, 2025
What to do if minimum pressure alarm sounds continuously in Heyer Pasithec Medical Equipment?
- J
  johnsoncharlesAug 25, 2025
  If the minimum pressure alarm sounds continuously on Heyer Medical Equipment, check the following: Inspect the breathing system for leaks. Reset the alarm settings if they are too high. Check the patient. Inspect the pressure sampling pipe.
A
Andrew HenryAug 28, 2025
Why my Heyer Medical Equipment ventilator stops suddenly and the alarm sounds?
- A
  aromeroAug 28, 2025
  If your Heyer Medical Equipment ventilator stops suddenly, the indicator light turns off, and an alarm sounds, it indicates that the power supply has been interrupted. Use manual ventilation.
S
Stephen BennettSep 1, 2025
How to troubleshoot no indication from the airway pressure gauge on Heyer Pasithec Medical Equipment?
- A
  Amanda VaughnSep 1, 2025
  If there is no indication from the airway pressure gauge on your Heyer Medical Equipment, check if the pressure sampling pipe is disconnected and reconnect it. Also, verify that the gas supply is not exhausted and replace it if necessary.
Y
yatesanneSep 4, 2025
What causes tidal volume readings to not display normally on Heyer Medical Equipment?
- T
  troy82Sep 5, 2025
  If tidal volume readings are not displaying normally on your Heyer Medical Equipment, it could be due to a disconnected flow sensor. Reconnect the flow sensor. Alternatively, the sealing ring of the bellows base might be broken. Check the bellows and replace any broken parts.
R
riveraderekSep 8, 2025
Why is there excessive pressure caused by manual ventilation with Heyer Medical Equipment?
- O
  oliviafritzSep 8, 2025
  Excessive pressure during manual ventilation with Heyer Medical Equipment can be caused by incorrect adjustment of the APL valve. Adjust it properly.