4.5.5 Changing to static IP address mode
1. Click Network from any web page of the printer.
2. Select Use the following IP address, which prepares the printer to use network settings (that you have
manually set).
Note: These manual settings are used the next time the printer is rebooted.
3. Enter the required IP Address and Subnet Mask network settings for Ethernet communications from
within the same subnet.
With only these entries, you are unable to print from a subnet other than the subnet on which the
printer is connected.
4. Enter the optional Default Gateway network setting for Ethernet communications across a router from
other subnets.
5. Enter the optional DNS Server Address and DNS Domain Suffix network settings for DNS.
6. Select Submit to save these changes to the stored settings in the memory of the printer.
Note: These settings are not lost if the power is removed from the printer.
7. Log in as a root user if you are prompted.
Note: Changes in settings are only accepted after you have successfully logged in.
8. Reboot the printer to save this change. See Section 4.1 We b page security.
July 2019 19
L001675, 1.2 Ethernet web pages - standard procedures
To Next Page
Loading...
Need help?
General
