3.2.2 Telnet command table
The following table describes available Telnet commands.
Note: You can enter partial full-word commands, the printer responds with additional help. For example,
you can enter “list”, and the printer responds with all subcommands to the list command.
Telnet Command Command Purpose Command Format
? Display help for Telnet commands. ?
help
reset Reset the Ethernet interface for the Printer/Encoder. reset
ping Send a ping command to another IP address as a
test of the Ethernet interface.
ping <IPADDR>
diff Display all differences between current and stored
network settings.
list diff
uptime Display how long since the interface was last reset. list uptime
sysinfo Display information about the printer (i.e., model,
label, contact, location, Firmware version and date,
and serial number).
list sysinfo
ribbon Display information about the installed Ribbon in the
printer.
list ribbon
net Display information about the current network
settings of the Ethernet interface.
list net
stored net Display information about the stored network
settings of the Ethernet interface.
list stored net
default net Display information about the default network
settings of the Ethernet interface.
list default net
User Display information about the defined User names
and their type (root or guest privileges).
list User
lpq Display information about print jobs and their
settings.
list lpq
Printer Display information about the printer (i.e., model
number, Firmware version and serial number).
list printer
Printer sm Display information about the secure mark settings
of the printer.
list printer sm
10 July 2019
Telnet server L001675, 1.2
To Next Page
Loading...
Need help?
General
