4.12.3 Accessing the network setup menu
1. Apply power to the printer.
2. Ensure that the printer is connected to your network.
3. Wait up to one (1) minute to allow the printer to configure the IP address.
4. Select Options on the LCD.
5. Select Menu on the LCD.
6. Select Next on the LCD until the Network Settings menu entry appears.
7. Press Select when Network Settings appears on the LCD.
4.12.4 Changing the DHCP setting
1. See Section 4.5.1 Accessing the Network settings page to access the Network Settings menu or select
Options > Menu > Next > Network Settings.
2. Select Next on the LCD to view the DHCP menu entry.
n DHCP Enabled indicates that the automatic IP assignment is selected.
n DHCP Disabled indicates that the static IP assignment is selected.
3. Press Change to switch the DHCP setting.
4. If you change the setting, you are prompted to reboot the printer.
4.12.5 Changing the ANEG setting
The ANEG status indicates the current setting of the network configuration of the Ethernet interface.
n You can set this value explicitly to force the Ethernet interface configuration in cases where auto
negotiation fails.
n Failure of the automatic network configuration can cause slow data transmission, longer print times or
network connection problems.
1. See Section 4.5.1 Accessing the Network settings page to access the Network Settings menu or select
Options > Menu > Next > Network Settings.
2. Select Next on the LCD to view the ANEG: menu entry.
3. Press Change to change the auto negotiation setting for the printer, which rotates between the
following:
n ANEG: AUTO: Allows the auto negotiation between the printer and the host Ethernet interface.
n ANEG: Full Dup: Forces the full duplex communications between the printer and the host Ethernet
interface.
n ANEG: Half Dup: Forces the half duplex communications between the printer and the host Ethernet
interface.
4. If you change the setting, you are prompted to reboot the printer..
42 July 2019
Ethernet web pages - standard procedures L001675, 1.2
To Next Page
Loading...
Need help?
General
