4.8.5 Specifying UDP event logging
1. Click System Log.
n The messages are sent via UDP packets to the Syslog port (514) of the specified host.
n It is up to the host program to listen to these messages for processing.
n A syslog host program is necessary to use this method, such as, Kiwi Syslog Daemon or
WinSysLog.
2. Click the link for the log name you want to view or configure (the default choices are log1 or log2).
3. Select the UDP Syslog option.
4. Enter a valid IP address or domain name.
5. Click Submit.
6. Log in as a root user if you are prompted.
Note: Changes in settings are only accepted after you have successfully logged in.
32 July 2019
Ethernet web pages - standard procedures L001675, 1.2
To Next Page
Loading...
Need help?
General
