10. Click Reboot when requested.
4.10 Using the Help page
The Help page displays the help information.
1. Open this web page at the appropriate location by clicking the Help book icon at the top of each
page.
2. Review the web interface for the Ethernet-enabled printer.
4.11 Accessing the Ethernet status LEDs
The Ethernet status LEDs can be found on the back of the printer.
4.11.1 Reviewing the printer LED Table
LED Flash Rate
Indicates
Green LED (Left) On The Network link is present.
Off The Network link is not present.
Amber LED (Right) Off There is NO network traffic to this IP address.
Blinking There is network traffic to this IP address.
4.12 Restoring the factory settings for Ethernet
There may be times when you are unable to use the current configuration of the Ethernet interface.
Note: This could be because you have lost the password for your printer or you just cannot get it to work
properly.
4.12.1 Resetting the printer settings
The printer has a menu selection that allows the user names and passwords to revert to default. To reset
these settings, select Menu > Setup Printer > Network Settings > Reset Passwords.
4.12.2 Changing the printer LCD network settings
The printer/encoder displays new menu entries when
n The Ethernet option is installed and
n The printer has established communications to a host device.
You can use these procedures to change network settings by using the new LCD menus.
July 2019 41
L001675, 1.2 Ethernet web pages - standard procedures
To Next Page
Loading...
Need help?
General
