HID HDP 5000 User Manual

4.6 Print Path page
The Print Path page allows you to view or change the TCP port numbers used to communicate with the
printer.
n If these settings are left to the default entry of 0 then the default ports of 9100, 5400 and 5402 are
used for the RawSocket TCP Port, the CPS Data TCP Port and the CPS Command TCP Port
respectively.
n The CPS Command TCP Port is dependent on the setting of the CPS Data TCP Port and always two
units higher.
1. Click Print Path.
2. View the active configuration of the printer in the Current Settings area on this page.
3. Enter new port numbers in the Stored Settings area on this page.
4. Click Submit to save these changes to stored settings in the memory of the printer.
Note: These settings are not lost if the power is removed from the printer.
July 2019 21
L001675, 1.2 Ethernet web pages - standard procedures

HID HDP 5000 Specifications

General

Brand	HID
Model	HDP 5000
Category	Printer
Language	English