Telnet Command Command Purpose Command Format
set sysinfo contact Set the contact string. set sysinfo label [<STRING>]
location Set the location string. set sysinfo location [<STRING>]
label Set the label string. set sysinfo label [<STRING>]
from Set all strings from default or current settings. set sysinfo from default|current
syslog name Change the name of a system log path set syslog <LOG_NAME> name
<NEW_NAME>
type Change the type of a system log path. This starts or
stops logging on start of jobs or on faults.
set syslog <LOG_NAME> type
[[-]job] [[-]pfault]
dest Change the destination of a system log path. This
may be set to none, e-mail, udp or tcp.
set syslog <LOG_NAME> dest
none|email|udp|tcp
email Change the e-mail address for e-mail notification for
a system log path. It must specify a valid e-mail
address.
set syslog <LOG_NAME> email
<EMAIL>
udp Specify the IP address of the UPD system logging
program.
set syslog <LOG_NAME> udp
<IPADDRESS>
from Restore system log path settings from the default or
current settings.
set syslog from default|current
set User add Add a new User definition.
The printer allows only two (2) User definitions.
set User add <NAME>
del Delete a User definition. set User del <NAME>
passwd Define a new password for a User. set User passwd <NAME>
[<PASSWORD>]
type Specify a User as root or guest.
Only root Users have administrative rights to change
network interface settings.
set User type <NAME> root|guest
from Restore User setting from default or stored settings. set User from default|stored
July 2019 11
L001675, 1.2 Telnet server
To Next Page
Loading...
Need help?
General
