HID HDP 5000 User Manual

Telnet Command Command Purpose Command Format
store net addr Store a new IP address. store net addr <ADDRESS>
mask Store a new address mask. store net mask <MASK>
gateway Store a new default gateway. store net gateway <ADDRESS>
dns Store a new DNS server address. store net dns <ADDRESS>
domain Store a new DNS domain suffix. store net domain <STRING>
opts Enable or disable automatic address assignment
using DHCP. Static (non-automatic) addresses will
come from the stored or default settings, depending
on the other settings.
To enable automatic address
assignment:
store net opts dhcp
To disable automatic address
assignment:
store net opts -dhcp
from Restore the network settings from either the default
settings or the current settings.
store net from default|current
ifc mode
Specify the Ethernet interface mode as:
automatic, full or half duplex; 10 or 100 mHz.
Note: 100 mHz. is not supported by the printer.
store ifc mode
auto|10half|10full|100half|100full
from Set the Ethernet mode settings from the default or
current settings.
store ifc from default|current
save Save all current settings as the stored settings in the
permanent memory.
save
load Take the settings from the stored memory and make
them the current settings.
load
lpstat Display information about the printer status.
This includes the status and device response.
See the printer web page description.
lpstat
cancel Cancel a specific print job from the print queue. cancel 10
quit Stop the current Telnet session. quit
12 July 2019
Telnet server L001675, 1.2

HID HDP 5000 Specifications

General

Brand	HID
Model	HDP 5000
Category	Printer
Language	English