HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
134
2 Select the link for the log name you want to view or configure (the default choices
are log1 or log2).
3
Select the TCP Connection radio button.
4
Select Submit.
5 Login as a root User if you are so prompted. Any change of setting will only be
accepted after you have successfully logged in.
6 Use a host program such as Telnet to receive these TCP logging messages
(Note: Other programs such as HyperTerminal are also used to monitor TCP
connections). See below.
Telnet Client: You can use a Telnet client connected to the TCP port (log1
= 4010, log2 = 4011) rather than the default Telnet port (23).
Telnet Session: If there is a Printer at IP address 192.37.23.155 (and you
have configured log1 for TCP logging), then you could initiate a Telnet session
from a DOS window of a PC by entering Telnet 192.37.23.155 4010.
Log Messages: All system log messages would then be displayed in that
Telnet session window. (Note: This is a one way connection for logging only.
Any input to the Printer on this connection is ignored.)
To Next Page
Loading...
