HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
268
Using the Print Flip Angle Option
Use the Print Flip Angle option to set the position of the Flipper so it is level with the card
path after a flip operation.
Using the Print Flip Level Option
Use the Print Flip Level option to set the position of the Flipper so it is level with the card
path.
Using the Encoder Flip Angle Option
Use the Encoder Flip Angle option to fine tune the position of the Flipper. (Note: This is
done in relation to the Printer's built-in Encoder if your Printer is equipped with this option.)
Setting the Printhead Resistance
This is factory set. If the main board or the Printhead is replaced then adjust this number.
• Locate the Printhead Setting Number on the bottom of the Printhead.
• The number reads R=XXXX.
To Next Page
Loading...
