HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
55
Connecting Power to HDPii Printer
Caution: Do not plug in the USB cable until prompted to do so during the
installation of the HDPii Printer Driver. See the Printer Driver Installation Procedures
procedure.
Step Procedure
1 The Printer connections are shown in the Display below.
2 Power up the Printer first then connect the USB or Ethernet.
IMPORTANT NOTE: Do not connect the USB cable or Ethernet before the
printer has been powered up.
3 If the printer needs to be reset for some reason the recommended manner is
to do this from the LCD by selecting: Options,Offline,Restart; or by switching
off the power at a power strip or surge-suppressor.
Display A - Connecting the AC power cable to the power supply.
.
Display B – Conecting the power cable to the printer
To Next Page
Loading...
