HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
49
Adjustable Film Cartridge Details
Please note that not all cartridges need to be adjusted.
Please perform this
adjustment on printers that exhibit the walking issue described below. Only adjust the
cartridge if the film is walking towards either flange and is not tracking on the take up
spool properly.
It is necessary that the transfer film track straight across from the supply-side spool to
the take-up spool and not ‘walk’ toward one side or the other.
The set up for this procedure needs to be adjusted with a brand new roll of transfer
film.
Do not adjust the film cartridge
with a roll of transfer film that has already been
used. The results will not be accurate.
Once the cartridge and the new transfer film are adjusted properly, leave the adjusted
film cartridge in the printer it was adjusted for. Note: Do not swap cartridges
between printers.
To Next Page
Loading...
