HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
179
option to automatically adjust the transfer temperature (175.0 Celsius)
and the dwell times (2.0 seconds per inch) to defaults when non-custom
card type is chosen on Card tab.)
(Note: It will also adjust the necessary transfer temperature and the
dwell settings in the Driver to provide the optimal holographic InTM
performance.)
Using the Dual Sided Group Functions
The Dual Sided group checkboxes (shown below) are grayed out if no Output is
automatically found or if the Dual Sided is manually turned off. See the procedures in this
section for more instructions.
To Next Page
Loading...
