HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
224
Defines the Y coordinate for the lower left corner of the area
• Default = 0.000
• Upper limit = 2.173
a. Lower limit = 0.000
Using the Click and Drag capability
Click and drag the corners and the sides of an area to change size and location of area.
• The Horizontal, Vertical size and X, Y coordinates update accordingly.
Click and drag the area to change the location.
• The X, Y coordinates update accordingly.
Selecting “inches or mm” radio button
Choice of inches or mm changes to measurement type. (Note: This is similar to the choice
on the Card tab.)
• The inches radio button displays the area size and the location in inches.
• The mm radio button displays the area size and the location in mm.
To Next Page
Loading...
