HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
225
Using the Add and Delete buttons
Step Procedure
1
Use the Add button for these capabilities:
• Add an area default sized to .2 (at location “0” with focus on the added
area).
• Add multiple areas in the same location with the same affect (as if there
were only one area). (Note: Intersecting/overlapping areas do not
cancel each other out; instead, they act as one area.)
2
Using the Delete button to delete the area with focus from the graphic.
Selecting the Full Card
Step Procedure
1
Select the Full Card option to print the resin black (K) panel for all black
found within all areas of the image, as shown below.
• The Card image becomes fully black.
• The resin prints anywhere for black.
• The Add and Delete buttons become inactive and are grayed out.
• The Defined Area object size and location scroll controls become inactive
and are grayed out.
• The inches and mm dials become inactive and are grayed out.
To Next Page
Loading...
