HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
266
Using the Mag Top of Form Option
Use this option only if the Printer has a built-in Magnetic Stripe Encoder.
• If so, use this option to shift the starting point of where the Printer will begin encoding the
magnetic track data on a card's Magnetic Stripe.
• When adjusting this value, keep in mind that a card and its Magnetic Stripe will always
remain in the same relative position as the card travels through the Printer.
The diagram (below) represents:
• How the magnetic data will move in relation to the fixed position of a card's Magnetic
Stripe as a “positive” or “negative” Magnetic Offset value is entered.
• For this diagram, assume that the card is transparent and the card's Magnetic stripe can
be seen through the top or front side of the card.
To Next Page
Loading...
