HID HDPii - Using the Print Path Page

HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
143
Using the Print Path page
The purpose of the Print Path page is to allow the User to view or change the TCP port
numbers used to communicate to the Printer.
• If these settings are left to the default entry of 0 then the default ports of 9100, 5400 and
5402 will be used for the RawSocket TCP Port, the CPS Data TCP Port and the CPS
Command TCP Port respectively.
• The CPS Command TCP Port is dependent on the setting of the CPS Data TCP Port
and always two units higher.