HDPii High Definition Card Printer/Encoder User Guide L001130 Rev 1.4
52
Use this procedure to adjust the film if it is tracking toward the
GREEN Flange.
The film placement on the take-up spool should mirror the position of the film on the supply
spool.
If the film is biased on the take-up spool toward the GREEN flange adjust the peel bar by
turning the adjustment screw in the counter-clockwise
direction.
Step 1: Install a new roll of transfer film prior to making any adjustment.
(NOTE: Adjustment can not be done with used material).
Step 2: Using a flat blade screwdriver turn the adjustment screw ¼ turn counter-clockwise.
Step 3: Print 10 cards and verify film is tracking straight from supply spool to take-up spool.
If not, repeat step 2 & 3.
To Next Page
Loading...
